FREE Shipping on all orders over $50.00!
Axel Joost Elektronik

Vari Load

97,58 €
incl. 19% VAT
plus shipping and handling

Add to Cart:

  • Description
  • Details
  • Reviews

Vari Load


You know the szenario: you have installed the new beautful led flashers in your bike and now you have trouble with the flasher speed cause the new led lights have a much lower power consumption compare to the old bulbs, leading in faster flashes or any kind of other trouble with your ecu in your bike. However You can buy and try different load equalizer for your bike until you have spend much time and money and have found the right load equalizer for your bike. 

The basic idea came from a smart employer from Louis: The solution is a digital adjustable load - equalizer with 50 different presets. The Vari Load is connected to your flashers. The load is adjustable via a simple "programming" cable.


Vari lOad


The load is simple adustable by touching and holding the blue cable to + 12 Volt or ground. A touch and hold to + 12 Volt increases the load up to 15 Watt. Touching and holding the blue cable to ground result in a decrease of the load down to 0 Watt. A flashing led indicates the change of the load and the preset number. The led is permanent on if the minimum or maximum value is reach and switches off when you remove the blue cable and the adjusted value is stored in the Vari Load as preset. The time between the lowest load value and the maximum load value is about 20 seconds.

Please note that the Vari Load should only used in bikes if the maximum load is below 10 Watt. Higher load values above 10 Watt are only intended for a short term workshop use. Just feel free to use the Vari Load XL in a bigger housing what is available soon. The Vari Load XL can transmit the high temperatures better outside of the box.

By the way, the Vari Load can search for the right load with an automatic mode. Just wire the blue cable to groundbefore you switch on the ignition. Activate the flashers after switching on the ignition and the Vari Load start to search the correct load for your configuration by measurement of the flasher frequency and increasing the load slowly. The correct load value is stored in teh Vari Load when the flasher frequency is down to 90 flashes / minute.

By the way, the Vari Load is a cool tool for your workshop as well and belongs in every toolbox. You can adjust the required load value with the Vari Load at a customer bike and implement standard resistors against the Vari Load after you have figure out the right value. A printed table with the required resistors is in the manual.

Just feel free to download the manual for further infos. 


Dimensions: 56 mm x 37 mm x 17 mm
Body material: ABS
Input voltage range: 7 - 18 Volt
Connections: Inputs 0,14 mm², Outputs 0,75 qmm
Output power range: Between 2 x 1 Watt and 2 x 15 Watt
Maximum ambience temperature:    80 degree Celsius
  • 7 Units in Stock

Be the first to write a review.  Write a Review.

This product was added to our catalog on Wednesday 13 November, 2019.

Customers who bought this product also purchased...