Touch 2 Switch
This electronic relay have 2 independent channels. Each output can drive 70 Watt. The small size allow an installation in the handlebar or in the headlight. You can switch different loads with a push button. Two different inputs allow to control each output with the switch button, no matter if the button is wired to ground or to + 12 Volt.
The Touch 2 Swictch module can also be use as a standard toggle switch relay. Just wire the thin brown input cable direct to ground and the thin blue cinput able direct to + 12 Volt.That´s it. Now the module toggle between output 1 and output 2 if you press the button what is wired to the thin violet cable.
Advantages:
- Inputs for non-locking push-button switches in separate mode and for locking switches if the channels
are linked together.
- You can use very thin cables for the connection between the buttons and the module
- 2 independent channels, what can be linked together in order to increase the maximum load to 120 Watt.
- The small dimensions allow an implementation in the most handle bars.
- The module can also work as voltage inverter.
- Push-button switch (not latching) with connection to chassis or to + 12 Volt

Manual (PDF)
Dimensions: |
38 mm x 16 mm x 11 mm |
Body material: |
ABS with 2 k epoxy resin potted |
Input voltage range: |
6 - 18 Volt |
Connections: |
Inputs 0,14 mm², Outputs 0,75 qmm |
Maximum current: |
7 Ampere / 70 Watt per output |
Maximum ambience temperature: |
80 degree Celsius |